Blairg
New Member
Good morning all,
AM hoping for a little help to see what I am missing.
We are running a 1988 intergra motor in our 1986 CRX for the 24hrs of Lemons. We have replaced everything with Integra parts. Motor,wiring harness and ECU.
What the car has-
Cranking
Fuel pump working
Spark
new main relay
No codes
fuses checked
Grounds checked. Have two so far. Motor to support and a 3 into one ground in the engine compartment to motor block
Checked resistor for function. Got 6 ohms when checked on all four wires going to injectors.
Have 12v to the connector of the resistor when turned on.
What we don't have
It appears that we have no power to the injectors. Checked continuity between resistor pack and injectors and that checked out. I am going out to see if I can find a Noid tester today to make sure.
Any ideas would be appreciated.
Thanks
AM hoping for a little help to see what I am missing.
We are running a 1988 intergra motor in our 1986 CRX for the 24hrs of Lemons. We have replaced everything with Integra parts. Motor,wiring harness and ECU.
What the car has-
Cranking
Fuel pump working
Spark
new main relay
No codes
fuses checked
Grounds checked. Have two so far. Motor to support and a 3 into one ground in the engine compartment to motor block
Checked resistor for function. Got 6 ohms when checked on all four wires going to injectors.
Have 12v to the connector of the resistor when turned on.
What we don't have
It appears that we have no power to the injectors. Checked continuity between resistor pack and injectors and that checked out. I am going out to see if I can find a Noid tester today to make sure.
Any ideas would be appreciated.
Thanks
Last edited: