does anyone have an aem wideband?

Spody02

Name: Cody
so i just rebuild my motor for boost, buts its not boosted lol, and i wanted to make sure my air/fuel ratio was doing ok so i welded a bung into my stock exhaust and put it and when i go WOT it goes to like 12.5 til for like 2 seconds then like all the way to red side and off the gauge and shows that it 3 dashes, am i running super rich at WOT or what, its at like 14.9 for idle. Could it be a bad sensors or is my gauge broken or what?


thanks
 

Aussie

Zoom-Zoom
Why did you weld a bung in your stock exhaust? You should have just replaced your old o2 sensor. I don't know much about the aem but 12.5 is around lean max torque and 14.9 is lean idle so your ratios seem on. What's it reading when your at wot when it goes to the red side, is there any number it's giving you?
 

Spody02

Name: Cody
no it just goes to 3 bars, i think it just needed in be broken in, its working better, but i got bored and had 3 days off and wanted to use my new welder haha
 

Integra617

Chirp from 1st to 3rd!
hooww do you post new threads??. .i did it once and i cant figure out how to again. .HELP me plz! haha
 


Aussie

Zoom-Zoom
13:1 is lean man, between 11.5:1 and 12.5:1 is usually where your going to run most cars.
 


You must log in or register to reply here.
Top