Atomlab
New Member
I have an 89 teg and I odered these seals for the distributor and crank position sensor because I read they use the same seal.
http://www.autopartswarehouse.com/sku/NOK/Distributor_Seal/W0133-1640599.html?tlc=Engine+&+Drivetrain
Upon replacing the seals in the position sensor I found that the seals were not thick enough and I am wondering if it is different from the distributors seals? Should I even bother to take apart the distributor to replace the seals? Does anyone know the correct seals to use? Could I use a shim to fill the gap the new seals make?
http://www.autopartswarehouse.com/sku/NOK/Distributor_Seal/W0133-1640599.html?tlc=Engine+&+Drivetrain
Upon replacing the seals in the position sensor I found that the seals were not thick enough and I am wondering if it is different from the distributors seals? Should I even bother to take apart the distributor to replace the seals? Does anyone know the correct seals to use? Could I use a shim to fill the gap the new seals make?