Cat-back fitment help..

Walshie

''Gs-Rizzle''
Well i bought a cat-back from a friend and he said it was for a 2-door gs-r so I'm putting it on and all that, I mounted the cat-back up(with know axel back on yet) just with the rubber hangers and its liek 4-5 inches short from the cat and wont stretch or reach to get even close? did he sell me a ls cat-back? or amd I doing somehting wronge
 

GSROWNSU

New Member
yea that's really gay because mine did that too when i bought my new catback from magnaflow. I took advantage of having a lift and i made an extra pipe about 4 inches long and attacted it in between pipes 1 and 2 on the catback. If yours breaks off into 2 pieces before the axle-back piece u could do the same. I thought it was weird too i prolly should've sent it back to magnaflow but i figured i could make it work and it works fine now all i did was add the extra 4 inches of pipe in the middle. If you don't wanna mess around w/ that i would just get ur money back from him and find something else
 

nexgenintegra

1ac4u2nv
samething with my T1R exhaust it was a little short but that was because the high flow cat i put in was shorter than the stock one but anyway, still short just a different part.
 


Walshie

''Gs-Rizzle''
yeah this is lame... i have 43$ or so and no exuast shop is open...and no one is awake to help
 

nexgenintegra

1ac4u2nv
well what i did is i cut the header right before the O2 sensor got some piping and clamps from autozone, probably about 10 to 15 bucks and clamped it.

 

JDMB18civic

New Member
are you going to have it welded eventually? or just leave it like that?
 


obd1kenobi

CI Transfomer God!
YO Nexgenintegra!!! With your piping and stuff, do you have something still there to allow flex or the exhaust system to bend, I didnt see it in the picture!, if not over time the piping will brake, had that problem with my civics custom exhaust.
 
You must log in or register to reply here.
Top