FullCry
New Member
I have a 90 integra and a 95 wreck parts car. The seats in the 90 are all torn up but the ones in the 95 look like new. I measured the bolt hole spacing on both cars bucket seats and the 95 seats are one inch wider spacing and I could rig the seats and get them in but my question is. Are these seats made so that I can remove the seat rails from the 95 bucket seats, then remove the seat rails from the 90 model and put them on the 95 seats?I have replaced many honda seat rails so if it can be done I won't have any problem. I guess I could just take one out of each car and look but if someone knows I would appreciate feedback.
I guess I'll try to kill to dillers with one stone. The 90 model has auto passive seat belts on driver and pass. side front. The 95 has regular shoulder harness seat belts. If I had to rig the 95 seats in the car by drilling a few holes etc.--which I really don't won't to do, then I would have to remove the passive belts and unit attached between the front seats and rig the buckles and harness up where it normally mounts but of course there won't be a threaded hole. Has anyone done this? Also will the rear seat out of the 95 model fit in the 90 model? Thanks a lot for any replies, Humbly, FullCry
I guess I'll try to kill to dillers with one stone. The 90 model has auto passive seat belts on driver and pass. side front. The 95 has regular shoulder harness seat belts. If I had to rig the 95 seats in the car by drilling a few holes etc.--which I really don't won't to do, then I would have to remove the passive belts and unit attached between the front seats and rig the buckles and harness up where it normally mounts but of course there won't be a threaded hole. Has anyone done this? Also will the rear seat out of the 95 model fit in the 90 model? Thanks a lot for any replies, Humbly, FullCry