95 acura integra passenger signal doesn't work! Help!!

[norman19]

How's it going?
So I have a 1995 acura integra ls. The dash board and everything is original, so nothing was changed I got this car all stock. About 4 months ago I installed sidemarkers on my integra from the ep3 and they were working perfectly fine. They went with the signals witch I loved. Than I installed spacers into my car to add more poke to my wheels, tires began to rub on the inside of the fender, it rubbed so bad that it rubbed off the plastic part to my sidemarker wiring and the power wire hit the fender (which is a ground) and now I lost power to the smaller half (the side with 2 wires not 3) of my passenger side signal. Hazards work fine but doesn't get power to the same signal, flasher relay is fine. The fuse is fine because all the other signals work. I just don't know what else to do? I don't have a multimeter but I have a power light test thing. I removed the whole wire for the sidemarker and now the wiring to the passenger side is just normal connecting to itself like how I first got it. Besides now that half of my signal isn't getting power. So please help!!! Thank you and sorry if it's confusing!

 

[96LSteg]

sounds like you had your sidemarkers jerry rigged lol I would still pull the fuse and replace it just to say its been done. Also have you replaced the bulb? The bulb could have blown from the sidemarker grounding out. do that too and report back

 

[DCiFound]

Have you checked the plug to see if its burnt. Sometimes, aftermarket bulbs draw more power than stock, and causes the ground wire to melt. Check to see if your tires had rubbed against the wiring harness in the upper fender well. I saw someone on here, post a pic of it fraid(sp?). They re-wired and everything is back to normal