ciafromtexas
Original motor 300,000mi
Hey, my name is C. I'm the current FNG to the site.
1991 Acura integra LS B18A1 300,000+ miles on original motor.
My car has been idling rough for a while. Since October this is what I've changed
Fuel pump, fuel filter, pgmfi relay, distributor, tps, fpr, injectors, cleaned injector ports, new
plugs and wires. Start the car, it runs great until it gets warm, as soon as it's warm it idles abnormally. I can't even drive around the block without it dying. No oil or water leaks, new timing belt, water pump, tensioner 10,000 miles ago, timing dead on. Great compression, valves have been checked and adjusted. etc.
The first issue came about in October, I broke down in Baytown on 146. Code 16, fuel injectors.
Replaced and had the the same issue. Well I went on a spending spree and needless to say almost everything under the hood is new. It acts as if it is out of gas, when the pressure is dead on with the helm manual I have.
3 days ago i finally made it out of the neighborhood, and it was idling super low. When I got on the highway it cut out on me and code 1-oxy sensor was flashing on the ecu. Replaced and I'm still having the stalling issue. Any help would be great. Thanks in advance.
1991 Acura integra LS B18A1 300,000+ miles on original motor.
My car has been idling rough for a while. Since October this is what I've changed
Fuel pump, fuel filter, pgmfi relay, distributor, tps, fpr, injectors, cleaned injector ports, new
plugs and wires. Start the car, it runs great until it gets warm, as soon as it's warm it idles abnormally. I can't even drive around the block without it dying. No oil or water leaks, new timing belt, water pump, tensioner 10,000 miles ago, timing dead on. Great compression, valves have been checked and adjusted. etc.
The first issue came about in October, I broke down in Baytown on 146. Code 16, fuel injectors.
Replaced and had the the same issue. Well I went on a spending spree and needless to say almost everything under the hood is new. It acts as if it is out of gas, when the pressure is dead on with the helm manual I have.
3 days ago i finally made it out of the neighborhood, and it was idling super low. When I got on the highway it cut out on me and code 1-oxy sensor was flashing on the ecu. Replaced and I'm still having the stalling issue. Any help would be great. Thanks in advance.