90 Integra - Cup Holders and Windows

eggplntkng

New Member
I just got my 1990 Acura Integra and was bummed when I realized it didn't have cup holders. I can live without the powerlocks and I foresee sticking the drink between the seat and Ebrake to result in a mess that will stain my floor mats. Does anyone know if they made a console for the center with cup holders for the 3 dr or even the 4 dr? I've seen aftermarkets, but would like an Acura sanctioned component. Maybe one from an earlier or later model?

Ok... This isn't too important, but while I'm here... The power windows don't seem to seal properly when you roll them up. These cars don't have a top to the door. I replaced the window mounts in the door because they were loose, but it's like the seal on the outside top that they window is supposed to go in doesn't allow the glass to slip inside to create a seal. This leads to an annoying gap that leads to air gushing in and making loud sounds while cruising the interstate.

Any help on either would be appreciated.

Thanks. Ride on!
 

cdp382

New Member
armrest/ cupholder

There are 2 types of arm rest for the g2.. One was made for the Canadian model and then one for the American model. The american model can be found on g2ic.com from time to time. Both models are rare but can be found. You can look to pay anywhere from $100-$200 depending on the condition. If you need a picture of both, email me at dpintos382@yahoo.com
 


Top